System architecture
PV, diesel, wind and storage on one AC bus, or an AC/DC hybrid topology — designed around your load curve, not a catalogue.
Twenty-one engineering write-ups covering off-grid microgrids, grid-connected commercial and industrial storage, weak-grid support and product selection — with the field data behind each one.
The same hardware behaves very differently off-grid, behind the meter or on a weak grid. Start from the scene that matches your project and the articles are already filtered for you.
Maldives Island 6.3 MW Grid-Forming MicrogridEighteen 350 kW grid-forming PCS units are paralleled without inter-unit communication to create six 1.05 MW units, powering a Maldivian island resort with high reliability.
06
Maldives Island 6.3 MW Grid-Forming MicrogridEighteen 350 kW grid-forming PCS units are paralleled without inter-unit communication to create six 1.05 MW units, powering a Maldivian island resort with high reliability.
03
From desert oilfields to island resorts — these are working installations photographed on site, not renders.

Off-grid PV and diesel at a desert oilfield — the pumps run on daylight, the diesel runs only when it must.

Enclosures on site at a C&I project, cabled and commissioned before handover.

Our own assembly and R&D campus — where every cabinet is built and tested.

Multi-unit parallel and grid-tie testing in the lab, before anything ships.

The production line: enclosure assembly and wiring, stage by stage.

Cabinet-side commissioning and protection checks.
A microgrid is only as good as the engineering behind it. Four things we do on every project, at every scale.
PV, diesel, wind and storage on one AC bus, or an AC/DC hybrid topology — designed around your load curve, not a catalogue.
Virtual synchronous generator control delivers voltage and frequency support that lets weak grids accept more solar than they otherwise could.
Twenty-seven years of power-electronics manufacturing, from cell matching to cabinet assembly and full-system burn-in.
Remote EMS monitoring, firmware updates and local field service keep the system performing after handover.
A fixed sequence, so you always know what happens next and what we need from you.
Load curves, grid parameters, irradiance and diesel logistics — we collect what a desktop study cannot.
Sizing, topology, protection and the control strategy, delivered as a drawing set you can hand to your own engineer.
Enclosure assembly, wiring and staged testing in our lab before the equipment ships.
On-site grid connection, load ramp and operator handover, followed by remote monitoring.
Send us the location, load and whether you are on-grid, off-grid or on a weak grid. You will get a configuration proposal and an indicative price — usually within one working day.